– 72 –Chapter 4 Shooting — Special recording functions@@ NOTEt You can perform hot swap recording only in the microP2 memory card slot.t Change slots while recording is on stand-by. You cannot change slots during recording.t Hot swap playback is not supported.Recording check functionf After recording ends, press the button automatically to play back approximately three seconds of the latest video and audio.In this way, you can check whether video has been recorded properly. After playback, the camera is again ready to start recording.f Hold down the button for one second to play back from the last ten seconds of the latest clip. During playback at recording check,press the button again to stop the playback.Shot mark recording functionShot mark is the mark added to the thumbnail of each clip to distinguish that clip from others.Only clips with shot marks attached can be displayed or played back.Adding shot marks1 Assign [SHOT MARK] to one of [USER1] to [USER8] in the main menu → [USER SW].2 During recording or a pause after recording, press the button to which the shot mark is assigned.f [MARK ON] is displayed, and the shot mark is added to the most recently recorded clip.f Another press of the button displays [MARK OFF] and the shot mark disappears.@@ NOTEt When the shot mark is added during a recording pause, it is added to the clip recorded immediately before.t Shot marks can also be added while the thumbnail is being displayed. (page 113)t Shot marks cannot be added during loop recording, interval recording, or one-shot recording. If an operation is invalid, [SHOT MARK INVALID] isdisplayed when the button is pressed.t During playback, setting or canceling the shot mark is not available. While pausing the playback, setting or canceling the shot mark is available.t The following restrictions apply when adding shot marks to combined clips, such as those recorded over multiple microP2 memory cards, or whendeleting them.- All microP2 memory cards composed of clips must be inserted into the slots.- A shot mark is added only to the top clip among combined clips.Text memo recording functionText memos can be added to any video point while a clip is being recorded or played back.Only clips with a text memo added can be selected and displayed as thumbnails. Also, thumbnails at text memo positions can be displayed in order andplayed back from text memo points, and only required portions can be selected and copied. (page 113)Adding text memos1 Assign [TEXT MEMO] to one of [USER1] to [USER8] in the main menu → [USER SW].2 During recording or a playback, press the button to which the text memo is assigned.[TEXT MEMO] is displayed, and the text memo is added to the video clip that was displayed when the button was pressed.@@ NOTEt Up to 100 text memos can be recorded to a single clip.t Text memos cannot be added during loop recording, interval recording, or one-shot recording. If an operation is invalid, [TEXT MEMO INVALID] isdisplayed when the button is pressed.
