–19–Chapter 2 Description of Parts—Right sideRight side1872354616910111215131718141Eye cup (page30)2Eye piece3Busy (active status indication) lamp (page92)Indicate the active status of the SD memory card, and is illuminated when the card is active.4SD memory card slot (page92)This is the insertion slot for the SD memory card (optional). Use the SD memory card for recording/opening the setting menu of the camera, oruploading metadata or proxy recording, etc.@@NOTEtCautions when using SD memory cards-On the camera, use SD memory cards that conform to the SD standard, SDHC standard, or the SDXC standard. When performing proxyrecording, use SDHC memory cards, SDXC memory cards, or SD memory cards with the class description of class2 or higher.-MMC (Multi Media Card) cannot be used. (Bear in mind that taking pictures may no longer be possible if you use them.)-When using miniSD/microSD cards with the camera, always install the adaptor specially designed for miniSD/microSD cards. (The camera willnot work properly if only the miniSD/microSD adaptor is installed. Make sure that the card has been inserted into the adaptor before use.)-Use of Panasonic SD memory cards and miniSD/microSD cards is recommended. Be sure to format cards on the camera before use.-Refer to our support desk at the following website for the latest information not included in these operating instructions.http://pro-av.panasonic.net/-SDHC memory cards are a standard that was established in 2006 by the SD Association for large-capacity memory cards that exceed 2GB.-SDXC memory cards are a standard that was established in 2009 by the SD Association for large-capacity memory cards that exceed 32GB.5Recording button (grip side) (page45)Press this button to start recording. Press it again to stop recording.Used for direct shooting in thumbnail mode.6Power switch (page45)Switch on/off the power.7Microphone cable clamp (page31)Used for securing the microphone cable.8Pin holderAttach the zoom ring pin which is removed from the camera.9Headphones terminal (page164)This is the connecting terminal of headphones for audio monitor.1064)Connect the audio equipment or the microphone.11 terminal (page105)This is the output terminal for HD/SD SDI signals.12 terminal (page97)This is the input/output terminal for time code.Use the switch to select the input or output.13 terminal (page104)This is the input terminal for reference signals when setting the genlock to the camera section. This is the output terminal of the video for monitor.Use the switch to switch the input or output.14 switch (page102)Switch the input and output of the terminal and terminal.
