– 180 –Chapter 9 Network Connection — Preparing for connectionPreparing for connectionWhen using wireless module AJ-WM30Connect the wireless module AJ-WM30 (optional) to the camera. The grip belt can be removed.Fig. 1 button terminalFig. 21 Press the button and remove the cover by sliding it in the direction of the arrow. (Fig. 1)2 Connect the wireless module to the terminal. (Fig. 2)Insert it all the way.3 Slide the removed cover to close it.@@ NOTEt When removing the wireless module, pull it down straight.t When using a wireless module other than AJ-WM30, refer to “For wireless module other than AJ-WM30” (page 181).Storing the wireless module AJ-WM30The removed wireless module can be stored in the grip belt.Cautions when using wireless module AJ-WM30Read the operating manual of the wireless module thoroughly and understand it before using.To prevent accidental operation, there are restrictions as follows:f Supported standard: IEEE802.11g/nIEEE802.11a and IEEE802.11b cannot be used.f Communication frequency: 2412 MHz to 2462 MHz (1ch, 6ch, 11ch)12ch and higher cannot be used.r For use overseasThe following four types of products are available to comply with laws regarding radio wave of every region in the world. The products can be used onlyin the country or region where they are supported.f AJ-WM30MCPeople’s Republic of Chinaf AJ-WM30PUnited States of America, Canada, Mexico, Argentina, Peru, Taiwanf AJ-WM30EEU member nations, EFTA member nations, Australia, New Zealand, Russia, Ukraine, Saudi Arabia, UAE, Kuwait, Oman, Egypt, Republic of SouthAfrica, Korea, Philippines, Malaysia, Singaporef AJ-WM30Japan@@ NOTEt In France, using outdoors is prohibited.
