PLC-HF10000L Expand Serial Command Functional Specifications22/1058.4 Image Command8.4.1 CF_ CONT CommandCommand “CF_CONT_%1” [CR]%1“000-063”--------------- Directly specify setting value of Contrast“UP”--------------------- Increment setting value of Contrast by 1“DN”--------------------- Decrement setting value of Contrast by 1DetailsSet user controlled value of Contrast. (Available only in the normal Power ONstatus)The value set by this command is not stored in the projector. Therefore, when thepower is turned to ALL OFF status, the value returns to the original setting. (It isstored in Suspend mode.)Acceptable “000” [CR]ResponseUnacceptable “Error Code” [CR]8.4.2 CF_ BRIGHT CommandCommand “CF_BRIGHT_%1” [CR]%1“000-063” --------------- Directly specify setting value of Brightness“UP” ---------------------- Increment setting value of Brightness by 1“DN” ---------------------- Decrement setting value of Brightness by 1DetailsSet user controlled value of Brightness. (Available only in the normal Power ONstatus)The value set by this command is not stored in the projector’s memory. Therefore,when the power is turned to ALL OFF status, the value returns to the originalsetting. (It is stored in Suspend mode.)Acceptable “000” [CR]ResponseUnacceptable “Error Code” [CR]8.4.3 CF_COLOR CommandCommand “CF_COLOR_%1” [CR]%1“000-063”--------------- Directly specify setting value of Color“UP”--------------------- Increment setting value of Color by 1“DN”--------------------- Decrement setting value of Color by 1DetailsSet user controlled value of Color. (Available only in the normal Power ON status)The value set by this command is not stored in the projector’s memory. Therefore,when the power is turned to ALL OFF status, the value returns to the originalsetting. (It is stored in Suspend mode.)Acceptable “000” [CR]ResponseUnacceptable “Error Code” [CR]8.4.4 CF_TINT CommandCommand “CF_TINT_%1” [CR]%1“000-063”--------------- Directly specify setting value of Tint“UP”--------------------- Increment setting value of Tint by 1“DN”--------------------- Decrement setting value of Tint by 1DetailsSet user controlled value of Tint (Available only in the normal Power ON status)The value set by this command is not stored in the projector’s memory. Therefore,when the power is turned to ALL OFF status, the value returns to the originalsetting. (It is stored in Suspend mode.)Acceptable “000” [CR]ResponseUnacceptable “Error Code” [CR]