PLC-HF10000L Expand Serial Command Functional Specifications59/1058.9.57 CF_KEYDIS CommandCommand “CF_KEYDIS_%1” [CR]%1“NONE” ------------------------- RC & KEY are valid“RC” ----------------------------- RC is invalid“KEY” --------------------------- KEY is invalidDetails Set the limitation of RC/KEY use (Valid only when in the normal Power ON status)Acceptable “000” [CR]ResponseUnacceptable “Error Code” [CR]8.9.58 CF_SHUTRCPROT CommandCommand “CF_SHUTRCPROT_%1” [CR]%1 “ON” ------------------ Disable RC key from controlling Shutter (Protection On)“OFF” ----------------- Enable RC key to control Shutter (Protection Off)Details Set valid / invalid of RC use on Shutter control function(Valid only when in the normal Power ON status)Acceptable “000” [CR]ResponseUnacceptable “Error Code” [CR]8.9.59 CF_SHUTKEYPROT CommandCommand “CF_SHUTKEYPROT_%1” [CR]%1 “ON” --------- Disable key on the side panel from controlling Shutter (Protection On)“OFF” -------- Enable key on the side panel to control Shutter (Protection Off)Details Set valid / invalid use of key on the top panel on Shutter control function.(Valid only when in the normal Power ON status)Acceptable “000” [CR]ResponseUnacceptable “Error Code” [CR]8.9.60 CF_SHUTH CommandCommand “CF_SHUTH_%1” [CR]%1“005”-“480”----------Specify setting time directly“UP” ------------------ Add 1 minute“DN” ------------------Decrease 1 minuteDetailsSet time of operating shutter management function.(Valid only when in the normal Power ON status)The status set by this command is stored in EEPROM and setting remainseffective even after the power is turned to ALL OFF status.Acceptable “000” [CR]ResponseUnacceptable “Error Code” [CR]