PLC-HF10000L Expand Serial Command Functional Specifications24/1058.4.9 CF_WBAL- CommandCommand “CF_WBAL-%1_%2” [CR]%1“R” ------------- RED“G” ------------ GREEN“B” ------------- BLUE%2“000-063”------ Directly specify value of Color selected in %1 of White Balance.“UP”------ Increment setting value of Color specified in %1 of White Balance by 1“DN”----- Decrement setting value of Color specified in %1 of White Balance by 1DetailsSet value of Color specified in %1 of White Balance (Available only in the normalPower ON status)The value set by this command is not stored in the projector’s memory. Therefore,when the power is turned to ALL OFF status, the value returns to the originalsetting. (It is stored in Suspend mode.)Acceptable “000” [CR]ResponseUnacceptable “Error Code” [CR]8.4.10 CF_OFFSET- CommandCommand “CF_OFFSET-%1_%2” [CR]%1“R” --------- RED“G” --------- GREEN“B” --------- BLUE%2“000-063”------ Directly specify value of Color selected in %1 of Offset.“UP”------------ Increment setting value of Color specified in %1 of Offset by 1“DN”------------ Decrement setting value of Color specified in %1 of Offset by 1DetailsSet value of Color specified in %1 of Offset (Available only in the normal Power ONstatus)The value set by this command will not be stored in the projector’s memory.Therefore, when the power is turned to ALL OFF status, the value returns to theoriginal setting. (It is stored in Suspend mode.)Acceptable “000” [CR]ResponseUnacceptable “Error Code”[CR]8.4.11 CF_SHARP CommandCommand “CF_SHARP_%1” [CR]%1“000-031” -------------- Directly specify setting value of Sharpness.“UP”--------------------- Increment setting value of Sharpness by 1“DN”--------------------- Decrement setting value of Sharpness by 1DetailsSet user controlled value of Sharpness. (Available only in the normal Power ONstatus)The value set by this command is not stored in the projector’s memory. Therefore,when the power is turned to ALL OFF status, the value returns to the originalsetting. (It is stored in Suspend mode.)Acceptable “000” [CR]ResponseUnacceptable “Error Code” [CR]