PLC-HF10000L Expand Serial Command Functional Specifications56/1058.9.45 CF_P-MANE CommandCommand “CF_P-MANE_%1” [CR]%1“OFF” ---------------------------------- Set Power Management to Off“READY” ----------------------------- Set Power Management to Ready“SHUTDOWN” --------------------- Set Power Management to Shut Down mode“UP” ----------- The same operation as pressing Up key or Left key“DN” -----------The same operation as pressing Down key or Right keyDetailsSet/Cancel Power Management. (Valid only when in the normal Power ON status.)The status set by this command is stored in EEPROM and the setting remainseffective after the power is turned to ALL OFF status.Acceptable “000” [CR]ResponseUnacceptable “Error Code” [CR]8.9.46 CF_P-MANETIME CommandCommand “CF_P-MANETIME_%1” [CR]%1“01” - ”30” ----------------------- Directly specify setting time by the minute“UP” ----------- Increment value by 1 (Switched in 01→02→ --- → 30 → 01 order)“DN” ---------- Decrement value by 1 (Switched in 30→29→ --- → 01 → 30 order)DetailsSet time of Power Management time (Available only in the normal Power ONstatus). The status set by this command is stored in EEPROM and setting remainseffective even after the power is turned to ALL OFF status.Acceptable “000” [CR]ResponseUnacceptable “Error Code” [CR]8.9.47 CF_ON-STA CommandCommand “CF_ON-STA_%1” [CR]%1“ON” --------------------------- Set Direct on active.“OFF” ------------------------- Set Direct on inactive.“UP” ----------- The same operation as pressing Up key or Left key“DN” -----------The same operation as pressing Down key or Right key*”UP” and “DN” are exactly same operation.DetailsSet/Cancel Direct Power On (Only valid when it is in the normal Power ON status)The status set by this command is stored in EEPROM and the setting remainseffective after the power is turned to ALL OFF status.Acceptable “000” [CR]ResponseUnacceptable “Error Code” [CR]