Sanyo PLC-HF10000L - 10000 Lumens Manual

Also see for PLC-HF10000L - 10000 Lumens: Owner's manual Brochure Manual Specification sheet Owner's manual

Contents

PLC-HF10000L Expand Serial Command Functional Specifications41/1058.8 Lamp Command8.8.1 CF_LAMPMODE CommandCommand “CF_LAMPMODE_%1” [CR]%1“2LAMP” --------------- Set lamp mode to 2-lamps“1LAMPAUTO” ------ Set lamp mode to 1-lamp and automatically and preferentiallyuse a lamp with shorter cumulated lighting time.“1LAMP1” ------------ Set lamp mode to 1-lamp (LAMP1)“1LAMP2” ------------ Set lamp mode to 1-lamp (LAMP2)“CONSTANT” ------ Set lamp mode to Constant mode, and automatically switchbetween 2-Lamps mode and 1-Lamp mode, and/or modulatethe light to keep the target brightnessDetailsSelect Lamp mode. (Valid only when in the normal Power ON status.)The value set by this command is stored in EEPROM and the setting remainseffective after the power is turned to ALL OFF status.Acceptable “000” [CR]ResponseUnacceptable “Error Code” [CR]8.8.2 CF_ LAMPCONSTTAR CommandCommand “CF_LAMPCONSTTAR_%1” [CR]%1 “0000” - “1024”DetailsSet Target value for Constant mode of Lamp mode.(Valid only when in the normal Power ON status.)The value set by this command is stored in EEPROM and the setting remainseffective after the power is turned to ALL OFF status.Acceptable “000” [CR]ResponseUnacceptable “Error Code” [CR]8.8.3 CF_AUTOLAMPCONTRL CommandCommand “CF_AUTOLAMPCONTRL_%1” [CR]%1“NORMAL” ------------------------ Set Lamp status to Normal mode“ECO1” ------------------------------- Set Lamp status to Eco1 mode“ECO2” ------------------------------- Set Lamp status to Eco2 mode“AUTO” ----------------------------- Set Lamp status to Auto modeDetailsSelect Lamp control mode. (Valid only when in the normal Power ON status.)The value set by this command is stored in EEPROM and the setting remainseffective after the power is turned to ALL OFF status.Acceptable “000” [CR]ResponseUnacceptable “Error Code” [CR]8.8.4 CF_LAMPLIFECONTRL CommandCommand “CF_LAMPLIFECONTRL_%1” [CR]%1 “MODE1” -------------------------- Set Lamp life control mode to Mode1“MODE2” -------------------------- Set Lamp life control mode to Mode2DetailsSelect Lamp life control. (Valid only when in the normal Power ON status.)The value set by this command is stored in EEPROM and the setting remainseffective after the power is turned to ALL OFF status.Acceptable “000” [CR]ResponseUnacceptable “Error Code” [CR]