PLC-HF10000L Expand Serial Command Functional Specifications57/1058.9.48 CF_PJPINCODE CommandCommand “CF_PJPINCODE_%1” [CR]%1 “0000 – 9999” ------------- Directly specify PJ PIN codeDetailsEnter PIN code to cancel PIN code lock(Available only in the normal Power ON status)PIN code can not be changed. (Only PIN code lock is canceled.)*When PIN code Lock is enabled:PIN code is matched ------------------------- Command is valid (Acceptable)PIN code is mismatched -------------------- Command is invalid (Error code “102”)PIN code is beyond %1 available range ----- Command is invalid (Error code “?”)When PIN code lock is canceled:PIN code is within %1 range ----------- Command is valid (Acceptable)PIN code is out of %1 range ----------- Command is invalid (Error code is “?”)This command is only valid when “PJ PIN code” dialog is displayed to enter PINcode after Power is ON and Countdown is completed.When PIN code lock is set to “On1”, it needs to send this command every time theprojector is turned on.Acceptable “000” [CR]ResponseUnacceptable “Error Code” [CR]8.9.49 CF_FILH CommandCommand “CF_FILH_%1” [CR]%1 “RST” ---------------------- Reset Filter used timeDetails Reset used time for filter of projectorAcceptable “000” [CR]ResponseUnacceptable “Error Code” [CR]8.9.50 CF_FILTIMER CommandCommand “CF_FILTIMER_%1” [CR]%1“00400” ---------------------- Set 400 hours“00700” ---------------------- Set 700 hours“01000” ---------------------- Set 1000 hours“OFF” ---------------------- Set Off(Do not warning display)Details Set time to display Filter cleaning / replacement warning on screenAcceptable “000” [CR]ResponseUnacceptable “Error Code” [CR]8.9.51 CF_PTIMER CommandCommand “CF_PTIMER_%1” [CR]%1“START” -------------------------- Start P-timer“STOP” ---------------------------- Stop P-timer“RESTART” ---------------------- Resume P-timer“RST” ------------------------------ Reset P-timer“EXIT” ----------------------------- Exit P-timer functionDetails Select the status of P-timer.(Available only in the normal Power ON status)Acceptable “000” [CR]ResponseUnacceptable “Error Code” [CR]