PLC-HF10000L Expand Serial Command Functional Specifications29/1058.5.4 CF_V-POS CommandCommand “CF_V-POS_%1” [CR]%1“0000-nnnn” ------------ Directly specify setting value of Vertical Position“nnnn” indicates maximum value, which is current (Total Line – Display Area V) value“UP” --------------------- Increment setting value of Vertical Position by 1“DN” --------------------- Decrement setting value of Vertical Position by 1DetailsSet Vertical Position value in PC signal (Available only in the normal Power ONstatus)The value set by this command is not stored in the projector’s memory.Therefore, when the power is turned to ALL OFF status, the value returns to theoriginal setting. (It is stored in Suspend mode.)Acceptable “000” [CR]ResponseUnacceptable “101” [CR] --- When input is Video signal--- When input is no signal8.5.5 CF_CLAMP CommandCommand “CF_CLAMP_%1” [CR]%1“0000-4095” ----------- Directly specify setting value of Clamp“UP” --------------------- Increment setting value of Clamp by 1“DN” --------------------- Decrement setting value of Clamp by 1DetailsSet Clamp value in PC signal. (Available only in the normal Power ON status)The value set by this command will not be stored in the projector’s memory.Therefore, when the power is turned to ALL OFF stasis, the value returns to theoriginal setting. (It is stored in Suspend mode.)Acceptable “000” [CR]ResponseUnacceptable “101” [CR] --- When input is Video signal--- When input is no signal8.5.6 CF_DDOTS CommandCommand “CF_DDOTS_%1” [CR]%1“0256-nnnn” ----------------- Directly specify setting value of Display Dots“nnnn” indicates maximum value, which is current value of (Total Dots - Position H).In this projector, the value should be “even number” and if “odd number” is specified,it adds 1 to make the value even number.“UP” ------------------- Increment setting value of Display Dots by 2“DN” ------------------- Decrement setting value of Display Dots by 2DetailsSet Display Dots value in PC signal. (Available only in the normal Power ONstatus)The value set by this command is not stored in the projector’s memory. Therefore,when the power is turned to ALL OFF status, the value returns to the originalsetting. (It is stored in Suspend mode.)Acceptable “000” [CR]ResponseUnacceptable “101” [CR] --- When input is Video signal--- When input is no signal