Sanyo PLC-HF10000L - 10000 Lumens Manual

Also see for PLC-HF10000L - 10000 Lumens: Owner's manual Brochure Manual Specification sheet Owner's manual

Contents

PLC-HF10000L Expand Serial Command Functional Specifications28/1058.5 PC Control Command8.5.1 CF_FSYNC CommandCommand “CF_FSYNC_%1” [CR]%1“0000-0031” ----------------- Directly specify setting value of Fine Sync“UP” --------------------------- Increment setting value of Fine Sync by 1“DN” --------------------------- Decrement setting value of Fine Sync by 1DetailsSet value of Fine Sync in PC signal (Available only in the normal Power ON status)The value set by this command is not stored in the projector’s memory. Therefore,when the power is turned to ALL OFF status, the value returns to the originalsetting. (It is stored in Suspend mode.)Acceptable “000” [CR]ResponseUnacceptable “101” [CR] --- When input is Video signal--- When input is no signal8.5.2 CF_TDOTS CommandCommand “CF_TDOTS_%1” [CR]%1“mmmm – nnnn” --------------- Directly specify setting value of Total Dots“mmmm” indicates minimum value, which is current (Display Area H + Position H) value“nnnn” indicates maximum value, that dot clock does not exceed more than 160MHz.“UP” ------------------------- Increment setting value of Total Dots by 1“DN” ------------------------- Decrement setting value of Total Dots by 1DetailsSet value of Total Dots in PC signal (Available only in the normal Power ONstatus)The value set by this command is not stored in the projector’s memory. Therefore,when the power is turned to ALL OFF status, the value returns to the originalsetting. (It is stored in Suspend mode.)Acceptable “000” [CR]ResponseUnacceptable “101” [CR] --- When input is Video signal--- When input is no signal8.5.3 CF_H-POS CommandCommand “CF_H-POS_%1” [CR]%1“0000-nnnn” -------- Directly specify setting value of Horizontal Position“nnnn” indicates maximum value, which is current value of (Total Dots – Display Area H)“UP” ------------------- Increment setting value of Horizontal Position by 1“DN” ------------------ Decrement setting value of Horizontal Position by 1DetailsSet value of Horizontal Position in PC signal (Available only in the normal PowerON status)The value set by this command is not stored in the projector’s memory. Therefore,when the power is turned to ALL OFF status, the value returns to the originalsetting. (It is stored in Suspend mode.)Acceptable “000” [CR]ResponseUnacceptable “101” [CR] --- When input is Video signal--- When input is no signal