PLC-HF10000L Expand Serial Command Functional Specifications60/1058.9.61 CF_SHUTEFFECT CommandCommand “CF_SHUTEFFECT_%1” [CR]%1“OFF” --------Disable fade in and out function of Shutter“L1” --------- Set fade in and out function of Shutter to L1“L2” --------- Set fade in and out function of Shutter to L2DetailsSet Effect function of Shutter. (Valid only when in the normal Power ON status)When L1 is selected, projected image quickly fade in and out.When L2 is selected, projected image slowly fade in and out.The status set by this command is stored in EEPROM and setting remainseffective even after the power is turned to ALL OFF status.Acceptable “000” [CR]ResponseUnacceptable “Error Code” [CR]8.9.62 CF_SHUTRELEASE CommandCommand “CF_SHUTRELEASE_%1” [CR]%1 “ANY”----------------------------Enable to release Shutter with any key“SHUTTER” ------------------ Enable to release Shutter with only “SHUTTER” keyDetailsSet Release key of Shutter. (Valid only when in the normal Power ON status)The status set by this command is stored in EEPROM and setting remainseffective even after the power is turned to ALL OFF status.Acceptable “000” [CR]ResponseUnacceptable “Error Code” [CR]8.9.63 CF_DELAYCTRL CommandCommand “CF_DELAYCTRL_%1” [CR]%1“OFF”---------- Set Video delay control to OFF“LOW”---------- Set Video delay control to LOW“MID”----------- Set Video delay control to MID“HIGH”---------- Set Video delay control to HIGHDetailsSelect the mode of Video delay control(Valid only when in the normal Power ON status)The status set by this command is stored in EEPROM and setting remainseffective even after the power is turned to ALL OFF status.Acceptable “000” [CR]ResponseUnacceptable “Error Code” [CR]8.9.64 CF_CCAPTIONDISP CommandCommand “CF_CCAPTIONDISP_%1” [CR]%1“OFF” ------------- Select Off“CC1” ------------- Select CC1“CC2” ------------- Select CC2“CC3” ------------- Select CC3“CC4” ------------- Select CC4DetailsSelect channel of Closed caption.The status set with this command is stored in EEPROM and its setting is effectiveeven after ALL is OFF. This command is available in normal Power ON status.Note) Closed caption is available under conditions below;Entered signal is appropriate (NTSC signal from Video or S-video) or System isfixed to NTSC.Acceptable “000” [CR]ResponseUnacceptable “Error Code” [CR]