PLC-HF10000L Expand Serial Command Functional Specifications48/1058.9.16 CF_PIPMODEFREE CommandCommand “CF_PIPMODEFREE_%1” [CR]%1“USER1” --------------------------- Set User1 to Free status“USER 2” -------------------------- Set User2 to Free status“USER 3” -------------------------- Set User3 to Free status“USER 4” -------------------------- Set User4 to Free status“USER 5” -------------------------- Set User5 to Free statusDetailsDelete the data registered in Custom User1–5 and returns it to Free status.This command operates the same way as resetting to User1-5 in “Picture inPicture” Menu.(Available only in the normal Power ON status)*When there is only one user mode of stored state, return “101” [CR]Acceptable “000” [CR]ResponseUnacceptable “Error Code” [CR]8.9.17 CF_PIPRST CommandCommand “CF_PIPRST_%1” [CR]%1 “RST” ---------------------- Reset current setting statusDetails Reset current setting status of “Picture in Picture”.(Available only in the normal Power ON status)Acceptable “000” [CR]ResponseUnacceptable “Error Code” [CR]8.9.18 CF_EDGEBLENDING CommandCommand “CF_EDGEBLENDING_%1” [CR]%1 “ON” ---------------------- Set Edge blending to On“OFF” -------------------- Set Edge blending to OffDetailsSet Edge blending.(Available only in the normal Power ON status)The status set by this command is stored in EEPROM and setting remainseffective even after the power is turned to ALL OFF status.Acceptable “000” [CR]ResponseUnacceptable “Error Code” [CR]8.9.19 CF_BLEND CommandCommand “CF_BLEND_%1_%2” [CR]%1“LEFT” ---------------------- Left side“RIGHT” -------------------- Right side“TOP” ----------------------- Upper side“BOTTOM” ---------------- Lower side%2“000”-“1024”-------------------- Directly specify value of direction of %1*Value of upper limit changes by choice of %1Left ---------------------- 000~1024Right -------------------- 000~1024Top ---------------------- 000~540Bottom ----------------- 000~540DetailsSet the value of Width for direction specified by Edge blending %1.(Available only in the normal Power ON status)The status set by this command is stored in EEPROM and setting remainseffective even after the power is turned to ALL OFF status.Acceptable “000” [CR]ResponseUnacceptable “Error Code” [CR]