1 Before Using the Machine20The product may be configured to be compatible with other country networks.Please contact your Xerox representative if it needs to be reconnected to anothercountry's network.NOTE: Although this product can use either loop disconnect (pulse) or DTMF (tone)signaling it is recommended that it is set to use DTMF signaling. DTMF signalingprovides reliable and faster call setup. Modification, connection to external controlsoftware or to external control apparatus not authorized by Xerox, will invalidate itscertification.Regulatory Information for RFIDRegulatory Information for RFIDThis product generates 13.56 MHz using an Inductive Loop System as a RadioFrequency Identification device (RFID). This RFID device complies with therequirements specified in FCC Part 15, Industry Canada RSS-210, European CouncilDirective 99/5/EC, and all applicable local laws and regulations.Operation of this device is subject to the following two conditions:1. this device may not cause harmful interference, and2. this device must accept any interference received, including interference that maycause undesired operation.Changes or modifications to this equipment not specifically approved by the XeroxCorporation may void the user's authority to operate this equipment.Environmental ComplianceUSAENERGY STAR®As an ENERGY STAR® partner, Xerox Corporation has determined that this productmeets the ENERGY STAR guidelines for energy efficiency.The ENERGY STAR and ENERGY STAR MARK are registered United Statestrademarks. The ENERGY STAR Imaging Equipment Program is a team effortbetween U.S., European Union and Japanese governments and the office equipmentindustry to promote energy-efficient copiers, printers, fax, multifunction machine,personal computers, and monitors. Reducing product energy consumption helpscombat smog, acid rain and long-term changes to the climate by decreasing theemissions that result from generating electricity.Xerox ENERGY STAR equipment is preset at the factory. Your machine will bedelivered with the timer for switching to Sleep Mode from the last copy/print out, set at10 minutes. A more detailed description of this feature can be found in the Setupschapter in the System Administration Guide.
