453 CopyThis chapter contains information on the copy screens and the features available.NOTE: Some of the features described in this chapter are optional, and may not applyto your machine configuration.Copying ProcedureThis section describes the basic copy procedure. Follow the steps below.1. Load the Documents – page 452. Select the Features – page 473. Enter the Quantity – page 484. Start the Copy Job – page 485. Check the Status of the Copy Job – page 48Stopping a Copy Job – page 49NOTE: If the Authentication and Accounting feature is enabled, you may be requiredto enter your user ID and passcode (if they are set up) before using the machine. Forfurther information, contact the System Administrator.1. Load the DocumentsThe machine provides the following document input areas:• Document feeder - for single or multiple-page documents• Document glass - for single-page or bound documentsNOTE: The document glass cover will be installed in the non-document feederconfiguration.NOTE: The machine automatically detects standard document sizes. The sizes thatcan be detected vary depending on the paper size table specified by the SystemAdministrator. For more information on setting the paper size table, refer to the Setupschapter in the System Administration Guide. If the document is of a non-standard sizeor not identified as a standard size, the machine will prompt you to check thedocument or manually enter the document size. For information on how to enter adocument size manually, refer toOriginal Size on page 59.
