4 Fax781. Press the button on the control panel.2. Enter the correct user ID using the numeric keypad on the control panel or thescreen keyboard.NOTE: The default System Administrator ID is “11111”. If the Authentication andAccounting feature is enabled, you may also be required to enter a passcode. Thedefault passcode is “x-admin”. To change the default user ID or passcode, refer to theSystem Administration Guide.3. Press the button on the control panel.4. Select the [Tools] tab on the Machine Status screen.5. Under [System Settings], select [Common Service Settings].6. Select [Other Settings].7. Scroll down and select [Country].8. Select the required country. After saving the settings, the machine rebootsautomatically.NOTE: This setting is only available with the fax options for the countries statedabove.Fax ProcedureThis section describes the basic procedure for sending faxes, Internet Faxes, andServer Faxes. Follow the steps below:1. Load the Documents – page 782. Select the Features – page 793. Specify a Destination – page 804. Enter an E-mail Subject and Message (for Internet Fax Only) – page 815. Start the Fax Job – page 816. Check the Status of the Fax Job – page 82Stopping a Fax Job – page 82NOTE: If the Authentication and Accounting feature is enabled, you may be requiredto enter a user ID and passcode (if one is set up) before using the machine. Forfurther information, contact the System Administrator.1. Load the DocumentsThe following explains how to load documents using the document feeder or thedocument glass.The maximum capacity of the document feeder is shown below:Document Type (Weight) CapacityLightweight (38-49 g/m2 ) 75 sheetsPlain (50-80 g/m2 ) 75 sheetsHeavyweight (81-128 g/m 2 ) 50 sheets
