| Configuring Camera Settings | 160Allowing the Far-End System to Control Your CameraYou can allow the far-end to control your camera, so that the far-end can meet their watching need.To allow the far-end system to control your camera, meet the following conditions:• Enable the protocol of camera control.• Enable the feature of far control near camera (it is not applicable to VP59).Note: Note that during a call, you can use your VP59 to control the far-end camera, but the far-end cannotcontrol the camera of your VP59.• Camera Control Protocol• Configuring the Far Site to Control the Near CameraCamera Control ProtocolIf the remote wants to control your camera, both the remote and you should enable the camera control protocolsimultaneously. Your system supports FECC (Far End Camera Control) protocol. You can enable the FECC (H.323)protocol for the H.323 call and enable FECC (SIP) protocol for the SIP call.• Configuring FECC (H.323) Protocol• Configuring FECC (SIP) ProtocolConfiguring FECC (H.323) ProtocolFECC(H.323) protocol is used when controlling the far-site camera in H.323 calls. To control the far-site camera, thecall parties should enable this protocol simultaneously.Procedure1. Do one of the following:• On your web user interface, go to Account > VC Platform > Video Conference Platform > PlatformType > StarLeaf.• On your web user interface, go to Account > H.323.2. Configure and save the following settings:Parameter Description Configuration MethodFECC (H.323) Enable or disable FECC(H.323).Enables FECC (H.323) protocol,so that the remote can controlthe near camera.Default: On.Web user interfaceConfiguring FECC (SIP) ProtocolFECC(SIP) protocol is used when controlling the far-site camera in SIP calls. To control the far-site camera, the callparties should enable this protocol simultaneously.Procedure1. Do one of the following:• On your web user interface, go to Account > VC Platform > Video Conference Platform > PlatformType > Zoom/Pexip/BlueJeans/EasyMeet / Videxio/Custom.• On your web user interface, go to Account > SIP Account/SIP IP Call.2. Configure and save the following settings: