| Configuring Network Settings | 53• Configuring IP Addressing Mode• Configuring IPv4• Configuring IPv6Configuring IP Addressing ModeProcedure1. Do one of the following:• On your web user interface, go to Network > LAN Configuration > Internet Port > IPv4/IPv6.• On your VCS:For VC880/VC800/VC500/PVT980/PVT950, go to More > Setting > Advanced > Wired Network > IPMode.On your VC200, go to More > Network > Wired Network > IP Mode.On your VP59, go to Setting > Advanced > Wired Network > IP Mode.• On your CTP20, tap Setting > Advanced > Wired Network > Wired Network > IP Mode.2. Configure and save the following settings:Parameter Description Configuration MethodIPv4/IPv6/IP Mode Configure the IP address mode.Note: the default mode is IPv4.If you change this parameter, thesystem will reboot to make thechange take effect.Web user interfaceEndpointCTP20Configuring IPv4After connected to the wired network, the system can obtain the IPv4 network settings from a Dynamic HostConfiguration Protocol (DHCP) server if your network supports it. You can also configure IPv4 network settingsmanually.Before you beginMake sure that your network mode is set to IPv4 or IPv4&IPv6.Procedure1. Do one of the following:• On your web user interface, go to Network > LAN Configuration > IPv4 Config.• On your VCS:For VC880/VC800/VC500/PVT980/PVT950, go to More > Setting > Advanced > Wired Network > IPv4.On your VC200, go to More > Network > Wired Network > IPv4.On your VP59, go to Setting > Advanced > Wired Network > IPv4.• On your CTP20, tap Setting > Advanced > Wired Network > Wired Network > IPv4.2. Configure and save the following settings: