| Configuring Network Settings | 61Parameter Description Configuration MethodOption Specify the DHCP optionfrom which the system obtainsthe VLAN settings. You canconfigure at most 5 DHCPoptions and separate them bycommas.Note: the value can be anyinteger from 128 to 254.Default: 132.If you change this parameter, thesystem will reboot to make thechange take effect.Web user interfaceWi-FiFor VC880/VC800/VC500/PVT980/PVT950: you need to connect a WF50 Wi-Fi USB Dongle to the system forconnecting to the wireless network. For VC200: you can connect to the wireless network directly.• Connecting to the Wireless Network• Viewing the Wireless Network Status• Forgetting a Wi-Fi• Disabling the Wi-Fi FeatureConnecting to the Wireless NetworkThere are two ways to connect to the wireless network:• Manually connect to an available wireless network• Manually connect to hidden wireless networkWhen the system connects to a wireless network, the Wi-Fi icon will display on the status bar. The Wi-Fi iconindicates the signal strength. The more arcs you see, the stronger the signal strength is.Note: If you connect the codec to the wireless network via CTP20, make sure that CTP20 is wired to thecodec.• Connecting to the Wireless Network• Connecting to a Hidden Wireless NetworkConnecting to the Wireless NetworkYou can manually connect your phone to a wireless network.Procedure1. Do one of the following:• On your VCS:For VC880/VC800/VC500/PVT980/PVT950, go to More > Setting > Advanced > Wi-Fi.On your VC200, go to More > Network > Wi-Fi.On your VP59, tap Setting > Network & Connection > Wi-Fi.• On your CTP20, tap Setting > Advanced > Wired Network > Wireless Network.2. Enable Wi-Fi.
