| Configuring the Meeting Room | 176Joining the MeetingIf the virtual meeting room requires no password, dial IP address or account to enter the virtual meeting room.If the virtual meeting room requires a password, dial IP##meeting password or meeting password@IP to enter thevirtual meeting room.Example:• The IP address of the moderator is 10.3.6.201.• The meeting password for virtual meeting room 1 is 123.• The meeting password for virtual meeting room 2 is 456.Participants can dial 10.3.6.201##123 or 123@10.3.6.201 to enter the virtual meeting room 1.Participants can dial 10.3.6.201##456 or 456@10.3.6.201 to enter the virtual meeting room 2.Without a meeting password or with a wrong meeting password, the call will fail.Related tasksPlacing a Call by Entering a NumberConfiguring Voice ActivationVoice activation displays the active speaker in largest pane. Other participants are displayed in a strip beside the activespeaker. When a new speaker is identified, the image of the previous speaker is replaced by the new speaker. Othervideo images remain unchanged. This feature is not applicable to VP59.About this taskNote:Voice activation is only applicable to PVT980/PVT950/VC880/VC800 system with a multipoint license. It isnot applicable to VC500/VC200 endpoint.Voice activation works only when the conference call has more than two participants.Procedure1. On your web user interface, go to Setting > Built-in MCU Setting > Conference Setting.2. Configure and save the following settings:Parameter Description Configuration MethodVoice Activation Enable or disable the voiceactivation feature.Default: On.Web user interfaceVoice Hold Active Duration Configure the voice activationinterval.Default: 1 seconds.If the voice duration of a speakeris greater than 1 second, thevideo image of this speaker isdisplayed in largest pane.Web user interface
