| Configuring the Security Features | 195Configuring the Security FeaturesThe following introduces how to configure the security features.• User and Administrator• Configuring the Auto Logout Time• Transport Layer Security (TLS)User and Administrator• Configuring an Administrator Password• Enabling the User RoleConfiguring an Administrator PasswordThe default administrator name is “admin” and the administrator password is “0000”. Only the user with theadministrator permission can change the password. For security reasons, you should change them as soon as possible.The administrator password for the system supports ASCII characters 32-126 (0x20-0x7E).Procedure1. Do one of the following:• On your web user interface, go to Security > Security.• On your VCS, go to More > Setting > Advanced > Password Reset.On your VP59, tap Setting > Advanced > Password Reset.• On your CTP20, tap Setting > Advanced > Password Reset.2. Configure and save the following settings:Parameter Description Configuration MethodUser Type Select the administrator. Web user interfaceOld Password/CurrentPassword Enters the old administratorpassword.Default: “0000 ”.Web user interfaceEndpointCTP20New Password Configure a new administratorpassword.Note: You can leave thepassword blank.Web user interfaceEndpointCTP20Confirm Password Enters the new configuredadministrator password.Note: The entered passwordmust be the same as the oneconfigured by the parameter“New Password”.Web user interfaceEndpointCTP20