| Configuring the Meeting Room | 177Configuring the View SwitchingThe view switching allows the video images on the monitor change automatically. It is initiated when the number ofparticipants exceeds the number of windows in the selected video layout.• Average Mode: Up to 9 video images can be displayed in the Equal N×N layout. When the number of participantsexceeds 9, all participants’ video images will be switched automatically. The video image of the active speaker isindicated by an orange border. If you share content, the PC content is fixed at the top-left corner and will not beswitched automatically.• 1+N Mode: Up to 8 video images can be displayed in the Speaker View layout and the 1+N layout. When thenumber of participants exceeds 8, all participants’ video images (except the active speaker) will be switchedautomatically. If you share content, the PC content is given prominence in the largest pane. The active speaker isfixed at the bottom-left corner, and other video images will be switched automatically.Note:The view switching is only applicable to VC880/VC800/PVT980/PVT950 system with a multipoint license. Itis not applicable to VC500/VC200 endpoint.• Configuring the Average Mode• Configuring 1+N ModeConfiguring the Average ModeIn Equal N×N layout, when the number of participants exceeds 9, all participants’ video images will be switchedautomatically. You can configure the switching mode.Procedure1. On your web user interface, go to Setting > Built-in MCU Setting > Video Layout > Average Mode.2. Configure and save the following settings:Parameter Description Configuration MethodView Switching Interval Configure the view switchinginterval.Note: the default value is 30seconds.The video images will beswitched automatically every 30seconds.Web user interfaceSingle View Round Switches one video image at atime.Web user interfaceFull Screen Round Switches all video images at atime.Web user interfaceConfiguring 1+N ModeIn Speaker View layout and 1+N layout, up to 8 video images can be displayed. When the number of participantsexceeds 8, all participants’ video images will be switched automatically. But the video images of active speaker andthe content are not be switched.Procedure1. On your web user interface, go to Setting > Built-in MCU Setting > Video Layout > 1+N Mode.
