5 From the Power Saver list, select the light setting the standard exit bin will use when in Power Saver mode.Note: For more information on Power Saver mode, see “Adjusting Power Saver” on page 71.6 Click Submit.Using the printer control panel1 Make sure the printer is on and Ready appears.2 On the home screen, touch .3 Touch Settings, and then touch General Settings.4 Touch the down arrow until Output Lighting appears.5 Touch Output Lighting.6 Touch the arrow button next to Normal/Standby Mode to select the light settings the standard exit bin willuse when in Ready or Standby mode.7 Touch the arrow button next to Power Saver to select the light setting the standard exit bin will use when inPower Saver mode.Note: For more information on Power Saver mode, see “Adjusting Power Saver” on page 71.8 Touch Submit.9 Touch .Reducing printer noiseUse Quiet Mode to reduce the printer noise.Note: See the table for the multiple settings that change when you select a Quiet Mode setting.Choose ToOn Reduce printer noise.• You may notice a reduction in processing speed.• Printer engine motors do not start until a job is ready toprint. You may notice a short delay before the first pageis printed.• Fans run at a reduced speed or are turned off.Off Use factory default settings. This setting supports theperformance specifications for your printer.To select a Quiet Mode setting:1 On the home screen, touch .2 Touch Settings.3 Touch General Settings.4 Touch Quiet Mode.Minimizing your printer's environmental impact73
