Command Manual – ARPH3C S7500E Series Ethernet Switches Chapter 1 ARP Configuration Commands1-9By default, the ARP source suppression function is disabled.Related commands: display arp source-suppression.Examples# Enable the ARP source suppression function. system-viewSystem View: return to User View with Ctrl+Z.[Sysname] arp source-suppression enable1.3.2 arp source-suppression limitSyntaxarp source-suppression limit limit-valueundo arp source-suppression limitViewSystem viewParameterslimit-value: Specifies the maximum number of packets with the same source IP addressbut unresolvable destination IP addresses that a port can receive in five seconds. Itranges from 2 to 1,024.DescriptionUse the arp source-suppression limit command to set the maximum number ofpackets with the same source IP address but unresolvable destination IP addressesthat a port can receive in five seconds.Use the undo arp source-suppression limit command to restore the default value,which is 10.Related commands: display arp source-suppression.Examples# Set to 100 the maximum number of packets with the same source address butunresolvable destination IP addresses that a port can receive in five seconds. system-view[Sysname] arp source-suppression limit 1001.3.3 display arp source-suppressionSyntaxdisplay arp source-suppression
