Command Manual – AAA RADIUS HWTACACSH3C S7500E Series Ethernet SwitchesChapter 1 AAA/RADIUS/HWTACACSConfiguration Commands1-731.3.16 secondary authorizationSyntaxsecondary authorization ip-address [ por-number t ]undo secondary authorizationViewHWTACACS scheme viewParametersip-address: IP address of the server, a valid unicast address in dotted decimal notation.The default is 0.0.0.0.port-number: Port number of the server. It ranges from 1 to 65535 and defaults to 49.DescriptionUse the secondary authorization command to specify the secondary HWTACACSauthorization server.Use the undo secondary authorization command to remove the configuration.Note that:z The IP addresses of the primary and secondary authorization servers cannot bethe same. Otherwise, the configuration fails.z The HWTACACS service port configured on the device and that of theHWTACACS server must be consistent.z If you configure the command for more than one time, the last configuration takeseffect.z You can remove an authorization server only when no active TCP connection forsending authorization packets is using it.Related commands: display hwtacacs.Examples# Configure the secondary authorization server. system-view[Sysname] hwtacacs scheme hwt1[Sysname-hwtacacs-hwt1] secondary authorization 10.163.155.13 491.3.17 stop-accounting-buffer enableSyntaxstop-accounting-buffer enableundo stop-accounting-buffer enable
