Command Manual – MSTPH3C S7500E Series Ethernet Switches Chapter 1 MSTP Configuration Commands1-131.1.12 reset stpSyntaxreset stp [ interface interface-list ]ViewUser viewParametersinterface interface-list: Clears the spanning tree statistics information on one ormultiple ports. You can provide up to 10 port lists, by each of which you can specify anindividual port in the form of interface-type interface-number, or a port range in the formof interface-type start-interface-number to interface-type end-interface-number, wherethe end port number must be greater than the start port number.DescriptionUse the reset stp command to clear the MSTP statistics information.The MSTP statistics information includes the numbers of TCN BPDUs, configurationBPDUs, RST BPDUs and MST BPDUs sent/received through the specified port(s)(STP BPDUs and TCN BPDUs are counted only for the CIST).Note that this command clears the spanning tree-related statistics information on thespecified port(s) if you specify the interface-list argument; otherwise, this commandclears the spanning tree-related statistics on all ports.Related commands: display stp.Examples# Clear the spanning tree-related statistics information on ports GigabitEthernet 2/0/1through GigabitEthernet 2/0/3. reset stp interface GigabitEthernet 2/0/1 to GigabitEthernet 2/0/31.1.13 revision-levelSyntaxrevision-level levelundo revision-levelViewMST region viewParameterslevel: MSTP revision level, in the range of 0 to 65535. The system default is 0.
