Command Manual – Information CenterH3C S7500E Series Ethernet SwitchesChapter 1 Information Center ConfigurationCommands1-20DescriptionUse the info-center snmp channel command to configure the channel to outputsystem information to the SNMP NMS.Use the undo info-center snmp channel command to restore the default channel tooutput system information to the SNMP NMS.By default, output of system information to the SNMP NMS is enabled with a defaultchannel name of snmpagent and a default channel number of 5.For more information, refer to the display snmp-agent command in the SNMP-RMONCommands.Examples# Set to output system information to the SNMP NMS through channel 6. system-view[Sysname] info-center snmp channel 61.1.20 info-center sourceSyntaxinfo-center source { module-name | default } channel { channel-number |channel-name } [ debug { level severity | state state } * | log { level severity | statestate } * | trap { level severity | state state } * ] *undo info-center source { module-name | default } channel { channel-number |channel-name }ViewSystem viewParametersmodule-name: Specifies the output rules of the system information of the specifiedmodules, which vary with devices. For instance, if information on ARP module is to beoutput, you can configure this argument as ARP.default: Specifies the output rules of the system information of all the modules allowedto output the system information. This configuration varies with devices.debug: Debugging information.log: Log information.trap: Trap information.level severity: Specifies the severity of system information, refer to Table 1-4 for details.state state: The state of system information output, which could be on (enabled) or off(disabled).
