Command Manual – MulticastH3C S7500E Series Ethernet SwitchesChapter 6 Multicast Routing and ForwardingConfiguration Commands6-96.1.6 ip rpf-route-staticSyntaxip rpf-route-static source-address { mask | mask-length } [ protocol [ process-id ] ][ route-policy policy-name ] { rpf-nbr-address | interface-type interface-number }[ preference preference ] [ order order-number ]undo ip rpf-route-static source-address { mask | mask-length } [ protocol[ process-id ] ] [ route-policy policy-name ]ViewSystem viewParameterssource-address: Multicast source address.mask: Mask of the multicast source address.mask-length: Mask length of the multicast source address, in the range of 0 to 32.protocol: Routing protocol, which can have any of the following values:z bgp: Specifies the BGP protocol.z isis: Specifies the IS-IS protocol.z ospf: Specifies the OSPF protocol.z rip: Specifies the RIP protocol.process-id: Process number of the unicast routing protocol, in the range of 1 to 65535.This argument must be provided if IS-IS, OSPF or RIP is the specified unicast routingprotocol.policy-name: Name of the multicast route match rule, a string of 1 to 19 characters.rpf-nbr-address: Specifies an RPF neighbor by the IP address.interface-type interface-number: Specifies an RPF neighbor by the interface type andinterface number. The interface type must not be Ethernet, GigabitEthernet, Loopbackor VLAN-interface.preference: Route preference, in the range of 1 to 255 and defaulting to 1.order-number: Match order for routes on the same segment, in the range of 1 to 100.DescriptionUse the ip rpf-route-static command to configure a multicast static route.Use the undo ip rpf-route-static command to delete a multicast static route from themulticast static routing table.By default, no multicast static route is configured.Note that:
