Command Manual – MulticastH3C S7500E Series Ethernet Switches Chapter 4 PIM Configuration Commands4-264.1.23 display pim rp-infoSyntaxdisplay pim rp-info [ group-address ]ViewAny viewParametersgroup-address: Address of the multicast group of which the RP information is to bedisplayed, in the range of 224.0.1.0 to 239.255.255.255. If you do not provide a groupaddress, this command will display the RP information corresponding to all multicastgroups.DescriptionUse the display pim rp-info command to view the RP information.Note that:z The RP information includes the information of RPs dynamically found by the BSRmechanism and static RPs.z Because a non-BSR router refreshes its local RP-Set only based on the receivedBSR bootstrap messages, the system does not delete an RP even if its expiry timeis 0. Instead, the system waits for the next bootstrap message from the BSR: if thebootstrap message does not contain information of the RP, the system will deleteit.Examples# View the RP information corresponding to the multicast group 224.0.1.1. display pim rp-info 224.0.1.1BSR RP Address is: 2.2.2.2Priority: 0HoldTime: 150Uptime: 03:01:10Expires: 00:02:30RP mapping for this group is: 2.2.2.2# View the RP information corresponding to all multicast groups. display pim rp-infoPIM-SM BSR RP information:Group/MaskLen: 224.0.0.0/4RP: 2.2.2.2Priority: 0HoldTime: 150