Command Manual – MulticastH3C S7500E Series Ethernet Switches Chapter 1 IGMP Snooping Configuration Commands1-21Parameterscurrent-interface: Sets the source address of IGMP group-specific queries to theaddress of the current VLAN interface. If the current VLAN interface does not have anIP address, the default IP address 0.0.0.0 will be used as the source IP address ofIGMP group-specific queries.ip-address: Sets the source address of IGMP group-specific queries to the specifiedaddress.DescriptionUse the igmp-snooping special-query source-ip command to configure the sourceIP address of IGMP group-specific queries.Use the undo igmp-snooping special-query source-ip command to restore thedefault configuration.By default, the source IP address of IGMP group-specific queries is 0.0.0.0.This command takes effect only if IGMP Snooping is enabled in the VLAN.Examples# Set the IP address of the interface of VLAN 2 to 10.1.1.1, with the subnet mask of255.255.255.0, and specify this IP address as the source IP address of IGMPgroup-specific queries. system-view[Sysname] interface vlan-interface 2[Sysname-Vlan-interface2] ip address 10.1.1.1 255.255.255.0[Sysname-Vlan-interface2] quit[Sysname] vlan 2[Sysname-vlan2] igmp-snooping special-query source-ip current-interface1.1.24 igmp-snooping static-groupSyntaxigmp-snooping static-group group-address [ source-ip source-address ] vlanvlan-idundo igmp-snooping static-group group-address [ source-ip source-address ] vlanvlan-idViewEthernet interface view, port group view
