Command Manual – IPv6 RoutingH3C S7500E Series Ethernet Switches Chapter 3 IPv6 OSPFv3 Configuration Commands3-4Use of this command is only available on the ABR that is connected to a stub area.You have two commands to configure a stub area: stub, defaulted-cost. You need touse the stub command on routers connected to a stub area to configure the area asstub.If multiple OSPFv3 processes are running, use of this command takes effect only forthe current process.Related commands: stub.Examples# Configure Area1 as a stub area, and specify the cost of the default route advertised tothe stub area as 60. system-view[Sysname] ospfv3[Sysname-ospfv3-1] area 1[Sysname-ospfv3-1-area-0.0.0.1] stub[Sysname-ospfv3-1-area-0.0.0.1] default-cost 603.1.5 display ospfv3Syntaxdisplay ospfv3 [ process-id ]ViewAny viewParametersprocess-id: Specifies the ID of an OSPFv3 process, ranging from 1 to 65535.DescriptionUse the display ospfv3 command to display the brief information of an OSPFv3process. If no process ID is specified, OSPFv3 brief information about all processes willbe displayed.Examples# Display brief information about all OSPFv3 processes. display ospfv3Routing Process "OSPFv3 (1)" with ID 0.0.0.0SPF schedule delay 5 secs, Hold time between SPFs 10 secsMinimum LSA interval 5 secs, Minimum LSA arrival 1 secsNumber of external LSA 0. These external LSAs' checksum Sum 0x0000Number of AS-Scoped Unknown LSA 0
