Paradyne GranDSLAM 4200 User Manual

Also see for GranDSLAM 4200: Installation guide

Contents

5. ATM Commands5-4 August 2002 4200-A2-GB20-00DLT-VCLThe DLT-VCL command deletes selected ATM interface Virtual Channel Links(VCL) that are not in use.Response FormatIf, in less than 2 seconds, a normal or error response cannot be sent, the followingacknowledgment response is sent:IP cAfter the above response, a new command input may be generated.Normal Response:sid yy-mm-dd hh:mm:ssM c COMPLD/* DLT-VCL:[tid]:aid_vcl:[ctag][:] */;Table 5-3. DLT-VCL Command ParametersDLT-VCL:[tid]:aid_vcl:[ctag][:];RESTRICTIONS: All parameters in this command are position-defined. If the VCL iscross-connected, the deletion fails.[tid] Identification of the target NE. The default value is null. The NE SIDcode is the only other valid value.aid_vcl Virtual Circuit Identifier for the Virtual Circuit. The value can bepreceded with AID=, but this is not required. Grouping and ranging areallowed. Enter any of in the following formats, replacing lower-caseparameters with the values given:NTVCL-vpi-vci: VCL in the NTLTVCL-rack-shelf-slot-circuit-vpi-vci: VCL in an LT circuit– rack: Rack number (1)– shelf: Shelf number (1)– slot: LT slot number (1)– circuit: DSL circuit on the LT (1−4)– vpi: Virtual Path Identifier (for LT vpi=0, for NT vpi=0−15)– vci Virtual Channel Identifier (for LT vpi=32−63,for NT vpi=32−1023)[ctag] Correlation tag (6 characters maximum) that links an input commandwith associated output responses. The default is 0.