Paradyne GranDSLAM 4200 User Manual

Also see for GranDSLAM 4200: Installation guide

Contents

14. System Commands4200-A2-GB20-00 August 2002 14-31SET-NE-ALLThe SET-NE-ALL command sets common configuration parameters associatedwith the NE.Table 14-25. SET-NE-ALL Command Parameters (1 of 2)SET-NE-ALL:[tid]:[aid_com]:[ctag]:::ne_nblk;RESTRICTION: All parameters in this command are position-defined.[tid] Identification of the target NE. The default value is null. The NE SIDcode is the only other valid value.[aid_com] Access Identifier for all common equipment. The value can be precededwith AID=, but this is not required. The value is COM.[ctag] Correlation tag (6 characters maximum) that links an input commandwith associated output responses. The default is 0.ne_nblk Named parameter block for NE. The block consists of one or more ofthe following parameters, each followed by an equal sign and a value. Ifnot specified, the values of these parameters remain unchanged.BOOTPVCI : ATM VCI of the PVC over which the NE issues BOOTPrequests (32−1023) for ATM-1. The default value is 32.BOOTPVPI: ATM VPI of the PVC over which the NE issues BOOTPrequests (0−15) for ATM-1. The default value is 0.MEMALM: Used to clear alarm condition indicating loss or corruption ofpersistent memory. The only valid value is CLEAR.MEMDNLD: Determines whether an external download is persistent inthe database (typically used to restore the database from the previousbackup version). The only valid value is ENABLED.DEFROUTER: IP address of default IP router. Values are:– ddd.ddd.ddd.ddd: IP address (ddd = 1−255)– NONE: No default IP router is used (default)NETPOS: Position of the NE in the access subnetwork. Value is HUB(NE is directly connected to the network).SNTP: Use of Simple Network Time Protocol to maintain NE clock.Values are:– ENABLED: Use SNTP– DISABLED: Use NE local time set by the command SET-DAT onpage 14-29.TZOFFSET: Offset of local time zone from GMT/UTC, in minutes(-780−780). The default is 0 minutes. Used by the system if SNTP isenabled.SNTPMODE: The SNTP mode. Valid values are:– MULTI: Multicast (default)– BROAD: Broadcast– UNI: Unicast (to server at SNTPIPADDR)