Paradyne GranDSLAM 4200 User Manual

Also see for GranDSLAM 4200: Installation guide

Contents

2. Using the Command Line Interface4200-A2-GB20-00 August 2002 2-7Turn-up Procedure for Inband ManagementProcedureTo turn up the GranDSLAM 4200 using inband management:1.Manual Mode: At the unit, configure the IP address, net mask, and next-hoprouter.DHCP Mode: Set the ATM1 physical address using the ED-IPPORT command(see ED-IPPORT in Chapter 8,IP Access Commands), or accept the default,which is based on the MAC address assigned to the unit.Later, when determining what IP address has been assigned via DHCP, lookfor the MAC address in the DHCP server table. The assigned address isnormally the address of the Ethernet port with the ATM physical addressappended (0101 for ATM-1 or 0202 for ATM-2). The RTRV-IPPORT commandretrieves IP port configuration information (see RTRV-IPPORT in Chapter 8,IPAccess Commands).2. At the NOC, build a PVC through the network to the unit using VPI/VCI 0,32and 1483 routed encapsulation. Then, configure routers, etc., as necessary toroute data from the NOC to the GranDSLAM 4200.3. Enable security for your GranDSLAM 4200 unit. Using the TL1 commandENT-USER-SECU, change the default login and password. Use the EMS toconfigure SNMP community strings, the SYSLOG server, and trap managers.4. Change the time, if necessary. The Simple Network Time Protocol (SNTP),which maintains the unit’s clock, defaults to enabled for multicast. However,you can change the time offset from Coordinated Universal Time (UTC) usingthe TZOFFSET parameter of the SET-NE-ALL TL1 command. SeeSET-NE-ALL in Chapter 14,System Commands for more information.Turn-up Procedure for Out-of-Band ManagementIn out-of-band management, you are managing the unit using the Ethernetinterface. This port is configured through the Console port.ProcedureTo turn up the GranDSLAM 4200 using the Ethernet interface:1. At the unit, enable the Ethernet port.2.Manual Mode: Assign an IP address, netmask, and next-hop router.DHCP Mode: Configure the DHCP server out of the Ethernet port.3. Configure routers, etc., as necessary to route data from the NOC to theGranDSLAM 4200.4. Reset the DHCP server and the SNTP since they default to managing from theATM interface (inband management).