Paradyne GranDSLAM 4200 User Manual

Also see for GranDSLAM 4200: Installation guide

Contents

15. Test Commands4200-A2-GB20-00 August 2002 15-7RLS-LPBK-T1The RLS-LPBK-T1 command releases any loopback currently active at the nearend of a specific T1 facility, including configured loopbacks (set with the commandOPR-LPBK-T1 on page 15-2) and inband loopbacks (set with DS1 inbandloopback codes).Response FormatIf, in less than 2 seconds, a normal or error response cannot be sent, the followingacknowledgment response is sent:IP cAfter the above response, a new command input may be generated.Normal Response:sid yy-mm-dd hh:mm:ssM c COMPLD/* RLS-LPBK-T1:[tid]:aid_ds1:[ctag][:] */;Error Response:sid yy-mm-dd hh:mm:ssM c DENY/* RLS-LPBK-T1:[tid]:aid_ds1:[ctag][:] */aid:ERRCDE=errcde/* error description */;Table 15-5. RLS-LPBK-T1 Command ParametersRLS-LPBK-T1:[tid]:aid_ds1:[ctag][:];RESTRICTIONS: All parameters in this command are position-defined. Port loopbacks are supported only on LT ports.[tid] Identification of the target NE. The default value is null. The NE SIDcode is the only other valid value.aid_ds1 Access Identifier for the T1 facility. The value can be preceded withAID=, but this is not required. Enter in the following format, replacinglower-case parameters with the values given:NTT1-circuit– circuit: DS1 circuit on the NT (1)[ctag] Correlation tag (6 characters maximum) that links an input commandwith associated output responses. The default is 0.