Paradyne GranDSLAM 4200 User Manual

Also see for GranDSLAM 4200: Installation guide

Contents

3. ADSL Facility Commands3-54 August 2002 4200-A2-GB20-00Table 3-42. RTRV-PROFILE-ADSLUPALM Response Parameters (1 of 2)Parameter Explanationtid Target NE identificationyy-mm-dd Year, month, and dayhh:mm:ss Hour, minute, and secondM Message generated in response to an input commandc If provided, ctag; otherwise 0COMPLD CompletedDENY Input command is denied/* */ Enclosed are human readable comments – unspecified formatadsl_profile_id As described for command parameters (see Table 3-41,RTRV-PROFILE-ADSLUPALM Command Parameters), except that ALLis not used.profile_scope As described for command parameters (see Table 3-41,RTRV-PROFILE-ADSLUPALM Command Parameters).profile_name A string of up to 32 characters that uniquely identifies the profile withinits scope.[adslprof_nblk] ADSL parameter block containing one or more of the following namedparameters (separated by commas):LOFS-L: Loss Of Frame Seconds (line). SNMP trap and TL1autonomous message are sent if the number of LOFS events in a15-minute interval meets or exceeds the selected value (0−900seconds, where 0 disables the messages). The default is 0.LOSS-L: Loss Of Signal Seconds (line). SNMP trap and TL1autonomous message are sent if the number of LOSS events in a15-minute interval meets or exceeds the selected value (0−900seconds, where 0 disables the messages). The default is 0.LOLS-L: Loss Of Link Seconds (line). SNMP trap and TL1 autonomousmessage are sent if the number of LOLS events in a 15-minute intervalmeets or exceeds the selected value (0−900 seconds, where 0 disablesthe messages). The default is 0.ES-L: Errored Seconds (line). SNMP trap and TL1 autonomousmessage are sent if the number of ES events in a 15-minute intervalmeets or exceeds the selected value (0−900 seconds, where 0 disablesthe messages). The default is 0.SES-L: Severely Errored Seconds (line). SNMP trap and TL1autonomous message are sent if the number of SES events in a15-minute interval meets or exceeds the selected value (0−900seconds, where 0 disables the messages). The default is 0.UAS-L: Unavailable Seconds (line). SNMP trap and TL1 autonomousmessage are sent if the number of UAS events in a 15-minute intervalmeets or exceeds the selected value (0−900 seconds, where 0 disablesthe messages). The default is 0.INCRATE-F: Increasing Rate (fast channel). SNMP rate change trapand TL1 autonomous message are sent if the current rate is ≥ theprevious rate plus this threshold (0-2176 kbps in 32 kbps increments,where 0 disables the messages). The default is 0.