3. ADSL Facility Commands3-4 August 2002 4200-A2-GB20-00ACT-PROFILE-ADSLALMThe ACT-PROFILE-ADSLALM command activates newly created ADSL alarmprofiles. See ENT-PROFILE-ADSLALM on page 3-26 for information on how tocreate a new ADSL alarm profile.Response FormatIf, in less than 2 seconds, a normal or error response cannot be sent, the followingacknowledgment response is sent:IP cAfter the above response, a new command input may be generated.Normal Response:sid yy-mm-dd hh:mm:ssM c COMPLD/* ACT-PROFILE-ADSLALM:[tid]:adsl_profile_id:[ctag][:] */;Error Response:sid yy-mm-dd hh:mm:ssM c DENY/* ACT-PROFILE-ADSLALM:[tid]:adsl_profile_id:[ctag][:] */errcde;Table 3-3. ACT-PROFILE-ADSLALM Command ParametersACT-PROFILE-ADSLALM:[tid]:adsl_profile_id:[ctag][:];RESTRICTIONS: All parameters in this command are position-defined. After a profile isactivated, its parameters cannot be edited.[tid] Identification of the target NE. The default value is null. The NE SIDcode is the only other valid value.adsl_profile_id Numeric identifier of a profile (1−30). Grouping and ranging are allowed.[ctag] Correlation tag (6 characters maximum) that links an input commandwith associated output responses. The default is 0.