5. ATM Commands5-6 August 2002 4200-A2-GB20-00ED-ATMPORTThe ED-ATMPORT command edits configuration data associated with an ATMport in the NE.Response FormatIf, in less than 2 seconds, a normal or error response cannot be sent, the followingacknowledgment response is sent:IP cAfter the above response, a new command input may be generated.Normal Response:sid yy-mm-dd hh:mm:ssM c COMPLD/* ED-ATMPORT:[tid]:aid_atmport:[ctag]:::[atmport_nblk]*/;Error Response:sid yy-mm-dd hh:mm:ssM c DENY/* ED-ATMPORT:[tid]:aid_atmport:[ctag]:::[atmport_nblk]*/aid:ERRCDE=errcde/* error description */;Table 5-5. ED-ATMPORT Command ParametersED-ATMPORT:[tid]:aid_atmport:[ctag]:::[atmport_nblk];RESTRICTIONS: All parameters in this command are position-defined.[tid] Identification of the target NE. The default value is null. The NE SIDcode is the only other valid value.aid_atmport Access Identifier for an ATM port. The value can be preceded withAID=, but this is not required. Grouping and ranging are allowed. Enterany of in the following formats, replacing lower-case parameters withthe values given:NTATM: ATM port in the NTLTATM-rack-shelf-slot-circuit: ATM port for an LT circuit– rack: Rack number (1)– shelf: Shelf number (1)– slot: LT slot number (1)– circuit: ADSL circuit on the LT (1−24)[ctag] Correlation tag (6 characters maximum) that links an input commandwith associated output responses. The default is 0.