System Settings101Allocate MemoryThis feature allows you to specify memory capacities required for printing and for thereceiving buffer for each interface.1. Select [Allocate Memory] in the[Features] menu.2. Change the required settings.Use the scroll buttons to switchbetween screens.3. Select [Close].PostScript MemorySpecifies the PostScript memory capacity within the range of 16.00-96.00 MB in 0.25MB increments using the scroll buttons or the numeric keypad. The currently availablememory will be displayed at the top of the screen with the following message: “MemoryAvailable: XXX MB.”Job Ticket Memory (WorkCentre 5225A/5230A)Specifies the job ticket memory capacity within the range of 0.25-8.00 MB in 0.25 MBincrements using the scroll buttons or the numeric keypad. The currently availablememory will be displayed at the top of the screen with the following message: “MemoryAvailable: XXX MB.”Receiving Buffer - USBSpecifies the input buffer memory capacity for the USB interface within the range of 64-1024 KB in 32 KB increments using the scroll buttons or the numeric keypad. Thecurrently available memory will be displayed at the top of the screen with the followingmessage: “Memory Available: XXX MB.”Receiving Buffer - LPDSpecifies the input buffer memory capacity for the LPD interface. The currentlyavailable memory will be displayed at the top of the screen with the following message:“Memory Available: XXX MB.”NOTE: When printing with the receiving buffer spooling set to [Spool to Memory] or[Spool to Hard Disk], each page within a job is printed in the sequence assigned by theoperating system. However, sometimes pages between different jobs may not beprinted in the intended sequence if, for example, printing multiple copies of a single 1-page job. In this case, set spooling to [No Spooling], the default, to maintain theintended printing sequence.NOTE: If [Job Submission Order] is selected under [LPD Print Queue] in [OtherSettings], this setting is fixed to [Spool to Hard Disk].• No SpoolingSpecifies no spooling. Allows you to change the input buffer memory capacity withinthe range of 1024-2048 KB in 32 KB increments using the scroll buttons or thenumeric keypad.• Spool to MemorySpecifies spooling to memory. Allows you to change the input buffer memorycapacity within the range of 0.50-32.00 MB in 0.25 MB increments using the scrollbuttons or the numeric keypad.
