Loading Paper19NOTE: Always load paper into the tray in the orientation shown in the diagram.3. Close the tray.The elevator rises and positions the paper for use.Bypass Tray (Tray 5)Tray 5 (Bypass) allows you to use a variety of paper types. Tray 5 (Bypass) is locatedon the left-hand side of the machine. A tray extension is provided to accommodatelarger sized paper. After loading paper stock in Tray 5 (Bypass), make sure that theTray 5 (Bypass) settings on the touch screen match the paper size and type of stockloaded. If they do not match, reprogramming is required. For more information onprogramming of Tray 5 (Bypass), refer to the Copy chapter in the User Guide.NOTE: To avoid paper jams, make sure that the paper size and paper type settingsare identical to the paper stock loaded.1. Load the paper neatly into Tray5 (Bypass), making sure that thepaper stock is in the center ofthe tray.NOTE: Do not load paper above themaximum fill line.NOTE: When making single/doublesided copies on perforated paper,load the paper to feed the opposite side of the perforated edge first. Feeding theperforated edge first might cause paper jams.NOTE: If, when making copies orprints on thick-stock paper, thepaper will not feed into the machine,apply a curl to the paper as shown inthe illustration above. Note however,that excessively bending or foldingthe paper might cause paper jams.NOTE: When loading envelopes,make sure the flaps are closed andthat the envelopes are oriented on the tray so that the edge with the flaps will enter themachine first. However, when loading C5-size envelopes, set them long edge feed sothat the edge with the flaps will face toward you.2. Slide the side guides towards the paper until they are just touching the edge of thestock.
