Scan to Mailbox Setup287Procedure for Scan to Mailbox Setup through CentreWare InternetServices1. From a workstation, open up a web browser (such as Internet Explorer), and thenenter the Internet address of the machine. If connected properly, you should seethe CentreWare Internet Services web page for your machine.NOTE: If you use the IP address to specify the machine, use one of the followingformats depending on your machine configuration. The IPv6 format is supported onWindows Vista only. An IPv6 address needs to be enclosed in square brackets.(For IPv4) http://xxx.xxx.xxx.xxx(For IPv6) http://[xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx]NOTE: If you have changed the port number from the default port number “80”,append the number to the Internet address as follows. In the following examples, theport number is 8080.(For IPv4) http://xxx.xxx.xxx.xxx:8080(For IPv6) http://[xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx]:80802. Create mailboxes:1) Click the [Scan] tab.2) Click the [Mailboxes] folder.3) Click the [Create] button for a mailbox.4) Enter the appropriate information.5) Click on [Apply].NOTE: If a passcode is set for a mailbox, users are prompted for the passcode whenthey access the mailbox.3. From the touch screen, select [Scan to Mailbox].1) Select the number of the mailbox to which you want to send a scanneddocument.2) Load a sample document into the document feeder.3) Press the button on the machine.4. Verify that the scanned document is in the mailbox:1) Select the number of the mailbox to which the scanned document was sent.2) Select [Document List].CentreWare InternetServicesOptional CentreWare Internet Services can be used tocreate/edit mailboxes and view/print scanneddocuments stored in mailboxes.Data to Set Up Scan toMailboxInstallRequirement Comments
