Common SettingsXerox WorkCentre 7132 User Guide 233Initialize Hard DiskThis feature allows you to initialize the hard disk on the machine. After selecting[Initialize Hard Disk], select a partition, and then select [Start]. Then select [Yes] toexecute initialization. After the initialization finishes, select [Confirm].NOTE: This process may take a while depending on the machine configuration.Delete All DataThis feature allows you to delete all document data on the machine. Select [Delete AllData], and then select [Start]. Then select [Yes] to execute deletion. After the deletionfinishes, you need to switch the machine off and then on.NOTE: This process may take a few hours depending on the machine configuration.Software OptionsSpecifies software options. For information on setting procedures and software codes,refer to the instructions for the required software option package. Enter passwords forthe software options using the keyboard screen and select [Reboot].Document Feeder Scanning PositionThis feature allows you to adjust the scanning position of the document feeder preciselyin the range in 0.1mm (0.004 inch) increments. Select [Factory Settings] to restore thedefault settings.Other SettingsThis feature allows you to configure various other settings common to the main featuressuch as copy, fax, and scan.1. Select [Other Settings] on the[Common Settings] screen.2. Change the required settings.Use the side tabs to switchbetween screens.3. Select [Close].Offset Stacking (Center Output Tray )Specifies the output paper stacking position for the Center Output Tray. When printing,the machine can slightly offset the paper output positions for each set (copies) or job(individually instructed print job). This allows you to identify the start of each set or job.Offset Stacking (Finisher Tray)Specifies the output paper stacking position for the Finisher Tray. When printing, themachine can slightly offset paper output positions for each set (copies) or job(individually instructed print job). This allows you to identify the start of each set or job.Downloaded From ManualsPrinter.com Manuals
