TroubleshootingXerox WorkCentre 7132 User Guide 399The machine displays a tray fault. • Follow the steps below.1. Open the paper tray.2. Move the paper tray guides away fromthe paper.3. Move the paper tray guides against thepaper so that they are just touching thepaper.4. Power the machine off and then on.Deformed transparencies • Check that [Transparency] is selected in[Paper Type]. The machine automaticallyadjusts the handling for transparencies.Transparencies tolerate less heat thanpaper.Blank output • Check that the document is loaded face upin the document feeder.• If the drum cartridge is new, the toner maynot be dispensed. Repeat the job.• Check that the seal tape has beenremoved from the new drum cartridge.• Reinstall the drum cartridge and the tonercartridge.• Replace the drum cartridge.• Replace the toner cartridge if the screenmessage for replacement is displayed.Streaks, solid or dotted lines, or spots • Clean the document glass, the CVT glass,the areas under the platen cover, thedocument feeder, and the paper guides.• Completely remove the ROS cleaner andreinsert the ROS cleaner to clean theraster output scanner.• If the machine has been idle for anextended period of time, or if the toner ordrum cartridge is new, begin the job again.• Run the job using the document glass.• Reinstall the drum cartridge.• Check the quality of the document. Use[Edge Erase] to remove lines and marksfrom the edges of the document.• Load fresh paper.• Check the humidity of the machinelocation.Output is too light or too dark. • Load fresh paper.• Check the quality of the document.• Select [Lighten/Darken] on the touchscreen.• Run off more prints until the copy qualityimproves.• Replace the drum cartridge.Symptom RecommendationDownloaded From ManualsPrinter.com Manuals
