Fault CodesXerox WorkCentre 7132 User Guide 423034-501 The telephone cable may not be connected securely. Check that the telephonecable is connected correctly, and resend the document. Refer to Telephonesocket in the Product Overview chapter on page 34.034-505 An error occurred using the fax. Turn the power off and on. Contact the XeroxWelcome Center if the problem persists.034-506 The remote copy function (printing multiple copies of a received document) isnot supported on the destination machine. Check if the destination machinesupports the remote copy function.034-507 Communication failed, because the password you specified does not match withthe ID number of the destination machine. Make sure that the password andtelephone number are correct. The destination machine may be set not to sendits own ID number. This code is also displayed when a polling request isrejected.034-508034-509034-510An error occurred when using the fax. If sending a fax, check the fax setting, faxnumber, and other settings, then perform the same operation again. Contact theXerox Welcome Center if the problem persists.034-511 A document for relay broadcasting cannot be transmitted. Check that the relaystation is correctly registered in the specified speed dial code. Also, check thecontents of the address number registered at the relay station.034-513 Received an invalid command. This is a Xerox remote maintenance systemoperational error. No user action is required.034-514 Received an unsupported request. This is a Xerox remote maintenance systemoperaional error. No user action is required.034-512 An endless loop was detected in the remote relay broadcasting. Check that therelay station is correctly registered in a speed dial number, and check the speeddial number points to the relay station.034-515 There is a problem on the remote machine. Check the remote machine status.034-519 The number of destinations exceeded the maximum number during broadcasttransmission. Wait for the pending jobs to decrease or reduce the number ofdestinations, then repeat the same operation.034-520 The number of jobs to be received exceeds the maximum number. Wait for thepending jobs to reduce and then repeat the operation.034-521 An internal error occurred. Turn the power off and on. Contact the XeroxWelcome Center if the problem persists.034-522 There is no phone line available for manual send communication. Wait untilcurrent transmissions to end, then perform the same operation again.034-523 The fax service has been disabled, and jobs cannot be received. Wait a while,then perform the same operation again.034-527 A dial control error occurred. Turn the power off and on. Contact the XeroxWelcome Center if the problem persists.Code Description and RemedyDownloaded From ManualsPrinter.com Manuals
