10 Setups264 Xerox WorkCentre 7132 User Guidecurrently available memory will be displayed at the top of the screen with the followingmessage: “Memory Available: XXX MB.”Other SettingsThis feature allows you to specify a printable area and replacement method whenpaper runs short.1. Select [Other Settings] on the[Print Mode Settings] screen.2. Change the required settings.Use the scroll buttons to switchbetween screens.3. Select [Close].Print AreaSpecifies the printable area. Select [Standard] to crop a margin 4.1 mm (0.16 inches)wide along all four edges of the paper. Select [Extended] to crop a margin of 2 mm (0.08inches) along the edges.Substitute TraySpecifies the substitute tray when the machine cannot detect the paper traycorresponding to the document size with the auto paper selection.Display MessageSpecifies a message prompt requesting paper supply be displayed without switchingpaper trays.Use Larger SizeSpecifies switching to the tray loaded with the next larger size of paper and prints thedocument in its original size.Use Closest SizeSpecifies switching to the tray loaded with the paper in the size closest to the selectedpaper. Image size may be automatically reduced as required.NOTE: The job sent from the PC takes priority over the job set on the machine.Select Tray 5 (Bypass)Specifies switching to the bypass tray.Paper Type MismatchSpecifies whether to print, display the confirmation screen, or display the paper supplyscreen when a paper type mismatch occurs.Downloaded From ManualsPrinter.com Manuals