Fault CodesXerox WorkCentre 7132 User Guide 407016-717 A [Transmission Report - Undelivered] or [Activity Report] was requested, butthe the required transmission result information is not stored in memory, and thereport was not generated. Take one of the following actions:• Partition memory intensive jobs (iFax) to limit the memory and the hard diskuse.• Execute any pending scan and iFax jobs after other scan and iFax jobs arefinished.• Request the report before 200 or more subsequent jobs have been executed.016-718 Unable to process PCL print data due to insufficient memory. Take one of thefollowing actions:• Lower the resolution.• Use no multiple-up or 2 sided print feature, and try printing again.016-719 Unable to process PCL print data due to insufficient print page buffer memory.Increase the print page buffer.016-720 PCL print data contained a command that could not be processed. Check theprint data, and then try printing again.016-721 An error occurred while printing a job. The Auto Tray Switching feature wasenabled when [Auto Paper Off] is selected for all paper trays on the [Paper TypePriority] screen. When the Auto Tray Switching feature is enabled, select apaper type other than [Auto Paper Off] on the [Paper Type Priority] screen.016-722 The specified stapling position is not supported. Check the staple position, andtry printing again.016-723 The specified punch position is not supported. Check the punch position, and tryprinting again.016-724 The combination of specified staple and punch options was imcompatible.Specify punch and staple position along the same edge of the paper and tryprinting again.016-725 A scanned document saved in a mailbox could not be converted to fax dataduring transmission processing using the job flow sheet. Do not use the job flowsheet. Instead scan the document, and send the fax directly.016-726 The printer language cannot be automatically selected when the print mode isset to [Auto], including:• PostScript data was sent without the PostScript Kit installed. Install thePostScript Kit.• A PDF file is sent directly to the machine, but unable to process the job. THehard disk drive may not be installed properly on the machine or may bedamaged. Contact the Xerox Welcome Center.• HP-GL/2 or PCL data is sent to the machine without the optional emulationkit. Install the emulation kit.016-727 The result of a print request is a zero-page document that cannot be stored in amailbox, and the job is canceled. Set the print option to print blank pages, andreprint to confirm if the output is not blank. Add text if the output is blank, and tryprinting again.Code Description and RemedyDownloaded From ManualsPrinter.com Manuals
