Yamaha YZF-R1(B) 2012 Service Manual

Also see for YZF-R1 2012: Service manual

Contents

CABLE ROUTING2-681. Rear frame2. Battery box 13. License plate light lead4. Left turn signal light lead5. Right turn signal light lead6. Battery box 27. Tail/brake light lead8. Lean angle sensor lead9. Lower tail cover bracket10.Main harness11.Starter relay12.Starter motor lead13.Battery cover14.Front frame15.Battery negative lead16.Plastic band17.Battery positive lead18.Lead cover19.Fuse box20.Tool band21.Battery seat22.Battery23.ToolA. Pass the main fuse lead through the guideof the battery box 1.B. Insert the main fuse until it is completelyover the tab projection of the battery box 2.C. Put the anti-theft alarm lead coupler infront of the dividing rib of the battery box 2for Australia.D. Route the tail/brake light lead through theleft of the battery box 2 boss.E. After passing the tail/brake light lead,license plate light lead, right turn signallight lead and left turn signal light leadthrough the guide of the battery box 2,route them between the ribs.F. When installing the seal, align it to thepush pin trace mark of the rear frame (bothleft & right).G. Slip the seal in between the rear frame andthe battery cover (both left & right).H. Align the positioning tape of the batterynegative lead to the clamp.I. Face the excess end of the plastic band toinside and the end should not be above thetool reception bearing surface of the bat-tery box 1.J. Align the positioning tape of the startermotor lead to the clamp.K. Up/down position of the battery negativelead and starter motor lead is shown in theillustration.L. Install the battery positive lead (red) on top.M. Put the lead cover on after connecting thestarter motor lead to the starter relay.N. Insert the fuse box until back of the tab ofthe battery box 2.O. BlackP. GreenQ. BrownR. BlueS. Installing direction of the tool is insignifi-cant.T. Bend the battery seat inward.U. Install the main harness with its tab fittedinside of the battery box 1.