CONNECTING RODS AND PISTONS5-824. Install:• Piston “1”(onto the respective connecting rod “2”)• Piston pin “3”• Piston pin clip “4”TIP• Apply engine oil onto the piston pin.• Make sure that the “Y” mark “a” on the con-necting rod faces left when the punch mark“b” on the piston is pointing up as shown.• Install the piston pin clips, so that the clipends are 3 mm (0.12 in) “c” or more from thecutout in the piston.• Reinstall each piston into its original cylinder.5. Lubricate:• Piston• Piston rings• Cylinder(with the recommended lubricant)6. Offset:• Piston ring end gaps7. Lubricate:• Crankshaft pins• Connecting rod big end bearing inner sur-face(with the recommended lubricant)8. Check:• Cylinder stud bolts9. Install:• Piston assemblies “1”(into the cylinder “2”)ECA14B1040If the projection “a” of the piston installingtool damages, you cannot use it. Pleasehandle with care.NewRecommended lubricantEngine oila. Top ringb. 2nd ringc. Upper oil ring raild. Oil ring expandere. Lower oil ring railA. Exhaust sideRecommended lubricantEngine oilCylinder stud bolt8 Nm (0.8 m·kgf, 5.8 ft·lbf)Piston installing tool90890-04161YM-04161
