Yamaha YZF-R1(B) 2012 Service Manual

Also see for YZF-R1 2012: Service manual

Contents

CABLE ROUTING2-521. Clutch cable2. Main switch lead3. Left handlebar switch lead4. Steering damper lead5. Horn lead6. Horn7. Brake hose8. Front brake light switch lead9. Throttle cable (decelerator cable)10.Throttle cable (accelerator cable)11.Right handlebar switch lead12.Throttle cable13.Hazard switch14.Lower bracket15.Steering damper bracket16.Front speed sensor lead17.Steering damper18.Brake hose holderA. After passing the clutch cable through theclutch cable guide, route it along and frontof the main switch.B. Make sure the main switch lead is not tightwhen turning the handle to the right of thestopper.C. Route the clutch switch lead outside of theleft handlebar switch lead.D. Fasten the brake hose at a position actualmeasurement of 50 mm (1.97 in) awayfrom the brake hose clasp, and the frontspeed sensor lead on the white tape.E. 50 mm (1.97 in)F. Route the front brake light switch leadunder the brake hose.G. Route the right handlebar switch leadabove the metal fitting on the brake hose.H. Route the throttle cable above the lowerbracket, inside of the front fork and underthe brake fluid reservoir hose. Throttlecable (accelerator cable) and throttle cable(decelerator cable) should not be twistedtogether.I. Fasten the horn lead back and inside of thesteering damper bracket projection.J. Steering damper bracket projectionK. Face the end of the plastic locking tie to theleft and cut off the excess end leaving 2–4mm (0.08–0.16 in).L. Outside of the vehicle.M. Inside of the vehicle.N. Fasten the front speed sensor lead withinthe area (90°) indicated by the arrowsshown in the illustration.O. Fasten the front speed sensor lead behindthe brake hose.P. Fasten the front wheel sensor lead on thewhite tape. Face the end of the plasticband to rear and to inside of the vehicle,and cut off the excess end leaving 5–10mm (0.20–0.39 in).Q. Fasten the front speed sensor lead on thewhite tape either in front of or beside thesteering damper motor. Face the end of theplastic locking tie to outside of the vehicleand cut off the excess end leaving 2–4 mm(0.08–0.16 in).R. Fasten the brake hose with the brake hoseholder.S. Right side.T. Left side.U. Fasten the brake hose and front speedsensor lead with the brake hose holder.