7.14 CAM Mode Objects 2887.14.1 Parameter: CAM Profile Memory Layout (0x380F) 2887.14.2 Parameter: CAM Status (0x3801) 2897.14.3 Parameter: CAM Control (0x3800) 2907.14.4 Parameters: CAM Profile 1–8 (0x3810–0x3817) 2917.14.5 Parameters: CAM Data 1–8 (0x3820–3827) 3017.14.6 Parameters: CAM Pattern 1–8 (0x3830–3837) 3017.14.7 Parameter: CAM Profile Selector (0x3804) 3027.14.8 Parameter: CAM Profile Status (0x3805) 3037.14.9 Parameter: CAM Slave Offset (0x3807) 3047.14.10 Parameter: CAM Slave Scaling (0x3809) 3057.14.11 Parameter: Minimum Blending Distance (0x380A) 3067.14.12 Parameter: Logical CAM Position (0x2020) 3077.14.13 Parameter: Logical CAM Set Point (0x2021) 3077.14.14 Parameter: Active Segment ID (0x2019) 3077.14.15 Parameter: Last Node ID (0x201A) 3087.14.16 Parameter: Logged Values (0x3870) 3087.14.17 Parameter: Digital Input Counters (0x3860) 3097.15 Gear Mode Objects 3097.15.1 Parameter: Gear Ratio (0x3900) 3097.15.2 Parameter: Gear Synchronization Option Code (0x3901) 3107.15.3 Parameter: Gear Master Start Distance (0x3902) 3117.15.4 Parameter: Gear Master Sync Position (0x3903) 3127.15.5 Parameter: Gear Slave Sync Position (0x3904) 3127.16 ISD Inertia Measurement Objects 3137.16.1 Parameter 52-60: Measured Inertia (0x2009) 3137.16.2 Parameters 52-61 and 52-62: Inertia Measurement Parameters (0x200A) 3147.17 Digital CAM Switch Objects 3147.17.1 Parameter: On Compensation (0x3840) 3147.17.2 Parameter: Off Compensation (0x3841) 3157.17.3 Parameter: Hysteresis (0x3842) 3157.17.4 Parameters: Digital CAM Switch Parsing Control (0x3843) 3167.17.5 Parameter: Digital CAM Switches Data (0x3844) 3187.18 Touch Probe Objects 3187.18.1 Parameter: Touch Probe Function (0x60B8) 3187.18.2 Parameter: Touch Probe Status (0x60B9) 3197.18.3 Parameter 51-51: Touch Probe 1 Positive Edge (0x60BA) 3207.18.4 Parameter 51-54: Touch Probe 1 Negative Edge (0x60BB) 3217.18.5 Parameter 51-61: Touch Probe 2 Positive Edge (0x60BC) 3217.18.6 Parameter 51-64: Touch Probe 2 Negative Edge (0x60BD) 321Contents Programming GuideMG36D102 Danfoss A/S © 01/2017 All rights reserved. 11
